Guest damor Posted December 6, 2005 Report Share Posted December 6, 2005 Are there any easy ways to set the timing points accurately when customizing a sequence to music? IS there a magic way ?Thanks dave. Quote Link to comment Share on other sites More sharing options...
alrobin Posted December 7, 2005 Report Share Posted December 7, 2005 Dave,I like to set the transition points by ear on the timeline, one after the other, as I listen to the playback of the music. Then, using the waveform, I revisit each point and drag it to the correct position in relation to the beat of the music as shown by peaks on the waveform. I set the transition point slightly ahead of the beat, the distance ahead being proportional to the length of the transition, as it takes a few milliseconds before one notices the start of a longer transition. Quote Link to comment Share on other sites More sharing options...
Guest damor Posted December 7, 2005 Report Share Posted December 7, 2005 Dave,I like to set the transition points by ear on the timeline, one after the other, as I listen to the playback of the music. Then, using the waveform, I revisit each point and drag it to the correct position in relation to the beat of the music as shown by peaks on the waveform. I set the transition point slightly ahead of the beat, the distance ahead being proportional to the length of the transition, as it takes a few milliseconds before one notices the start of a longer transition.Hi Al,Thanks for the tip,yet again.That is the way I have been doing it, but just off sync a little. The method of putting the slide a few milliseconds ahead, I did not do think of. However, will do now I just thought that you,the more experienced users, may have a magic wand or something. and not just a good ear for music Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.