Clone slide

[nelson]

I am having difficulty with a transition using windows 7- 64 bit.

I have a vertical slide that I would like to bring in from the side which is placed outside of view and want to place overtop of a background slide.

I add keyframe to about 3 or 4 seconds in to the transition which is where I want the slide to end.

Pretty basic stuff. Now if I want to maintain this position for a few seconds before moving it again I highlight the last keyframe, clone slide, and place a keyframe where I want it.

The problem I am having is the transition will now move to this point and end here.

There are times when this will work, most times not.

I am doing something wrong no doubt, can someone point me to a solution.

Thanks,

Kieron

[fh1805]

Keiron,

Why not simply add the new keyframe by clicking just under the O&A timeline (with the Animation tab having been previously selected) at the approximate place where you want the keyframe - and then adjust the timevalue and other parameters via the Animation tab?

regards,

Peter

[nelson]

Thanks for the quick reply, When you suggested animation I looked at the tab and I had used slow down.

If I use linear there is no problem everyting works as it should.

Many thanks,

Kieron

[davegee]

You can use Sow Down (or any other) if you go into Setting Up and click on SEPARATE HERE for each of the intermediate keypoints.

DG

[nelson]

Thanks Dave,

I had forgotten that aspect, many thanks.

Kieron