JEB Posted January 15, 2014 Report Share Posted January 15, 2014 Hi,Is there anyway that I can change the default setting within the "Adjust Image and Border" drop-down in O+A / Properties? I wish to be able to add a 0.2 border round a number of images rather than the default 3.4.I'm sure there must be other defaults that would benefit by being changeable in such a way.I tried to change as part of a Template with no luck.Any ideas?Jphn Quote Link to comment Share on other sites More sharing options...
PGA Posted January 16, 2014 Report Share Posted January 16, 2014 John,Set the first images as you want it to be, then click on the link "Save and use by default" at the bottom of the Properties tab in O&A. Now add the rest of your images. These will all have the border that you want. Beware: so will every image that you add to every project thereafter: until you set an image with no border and save that as your default.regards,Peter Quote Link to comment Share on other sites More sharing options...
JEB Posted January 16, 2014 Author Report Share Posted January 16, 2014 Peter,Thanks for that. This is just what I wanted. Approximately 90% of the images I will be using in this project require the same border. It is much simpler to change the 10%.CheersJohn Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.