Jump to content
WnSoft Forums

Banner printing

Boogie

By Boogie
in General Discussion

 Share

Recommended Posts

Boogie Senior Member

Boogie

Posted
Posted

I know this is not really a question relating to PTE, but this forum is so helpful for PTE users!!

I want to advertise a PTE created AV show with the use of a "banner" approximately 600mm long and 200mm deep on an A4 printer using cut paper or card.

The 200mm width is OK but I have not yet found how to print a sheet longer than the standard A4 length.

I use Serif Plageplus and Microsoft Word. I have created a 600mm wide page in PlagePlus, but can only print out a section after rotating the page through 90 degrees.

Does anyone know how to print off banners on an A4 printer using "continuous" paper? Is any special software required?

Boogie

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...