Banner printing

[Boogie]

I know this is not really a question relating to PTE, but this forum is so helpful for PTE users!!

I want to advertise a PTE created AV show with the use of a "banner" approximately 600mm long and 200mm deep on an A4 printer using cut paper or card.

The 200mm width is OK but I have not yet found how to print a sheet longer than the standard A4 length.

I use Serif Plageplus and Microsoft Word. I have created a 600mm wide page in PlagePlus, but can only print out a section after rotating the page through 90 degrees.

Does anyone know how to print off banners on an A4 printer using "continuous" paper? Is any special software required?

Boogie

[Graham]

Hi boogie

You can do this in Word. Just set your page setup to 600mm x what ever and when you print, set in "page dimensions" "user defined" at the bottom.

Graham

[Boogie]

Hi Graham

Thanks for your suggestion.

Following your note, I can now print out a 60cm long document in Word.

Many thanks for your response(even though it was not strictly PTE!!)

Boogie