A solution looking for a problem.

[MUR]

Hi
Playing around with the displacement of a wheel, I did this.
To be within the limit size of the forum, I am placing only the skeleton, but videos can be added, both inside the frame and outside, as master videos, because the transition between slides is 00 sec.
It is not intended to be useful, it is only a side effect of quarantine.

MUR

Wheels.zip

[Tonton Bruno]

Thank you for the sharing, Manuel.

I'll try to remember this animation which can be very useful.

[MUR]

Hi Tonton Bruno

It is just for fun and it is very easy, but it took a long time because I tried to do it in one slide, but it is difficult and at the end I used 12 independent slides, one for each stage of the movement.

MUR

[Tonton Bruno]

This is the way I usualy work.

I prepare a view with a duration of 3 seconds and only one keypoint at the begining and an other at the end to perform a simple animation.

Then I duplicate the view and move the keypoint from the end to the begining, and I crate a new keypoint at the end for the next simple animation.

[stranger2156]

1 hour ago, MUR said:

but it took a long time because I tried to do it in one slide, but it is difficult

Hi MUR,
an interesting experiment ... and if you try like this, it took quite a bit of time.

Weel_Jun12-2020_15-17-45.zip

[Tonton Bruno]

Awesome !

[MUR]

Hi 

I like it but, the problem was to solve easily the speed in the corners

Adapting your solution to constant speed.

MUR

 

 

 

 

 

Modif_Jun12-2020_12-01-07.zip

[stranger2156]

20 minutes ago, MUR said:

the problem is to solve easily the speed in the corners.

No additional key frames are needed to change the speed at bends (at corners). Move to the right the second keyframe in each pair, up to an interval of 0.5 seconds, and the speed will be uniform, both during movement and in turns.

[MUR]

Yes, I did it, view my last post

MUR