How to Not Show Image Until After Transition

[DS256]

I have found a solution but would like to check if there is an easier one I've missed.

I'm using Camera Transitions For PTE AV Studio but found my image showed as the transition started. The viewer then saw the image as well as the start of the transition.

My current approach is in Object's and Animations

1. At the first key frame, set OPACITY to 0.
2. Just before I want the image to appear, set another key frame again with OPACITY as 0 so there is not appearance.
3. A split second later, set another key frame with OPACITY 100.

Thanks for any improvement in this

I'm using 10.5.7

 

[davegee]

Try "Time Range".

Set the Start Time to the value of where your "100" KF would have been.

DG

[jt49]

You may set the opacity of the given first key frame to 0, and move this key frame to the right (to the position of your second key frame). Use another key frame to set opacity to 100.

[jienense]

18 hours ago, DS256 said:

but found my image showed as the transition started

Do you have the problem only on the first slide or on all of them? I have them installed and I don't see any problem

[DS256]

19 hours ago, davegee said:

Try "Time Range".

Set the Start Time to the value of where your "100" KF would have been.

DG

Thanks @davegee. Using 'Time Range' is a much simpler solution to the problem.

[DS256]

2 hours ago, jienense said:

Do you have the problem only on the first slide or on all of them? I have them installed and I don't see any problem

Interesting @jienense I copied/pasted a second slide and removed the TIME RANGE setting and it behaves properly.

This is only a test set so the first slide I have is a 5 second blank side before the one I was having problems with.

[denisb]

Hi,

 

the problem is that the first slide is a blank one. This is a problem with many Custom transitions

Put a black rectangle on the first slide.

Denis